11/20/2022 0 Comments Toyota techdoc europe'I cut down a scoket and welded it to a strip of steel to make a special tool to un-tighten \ tighten the tension pulley'. I've done this job on a 2002 D4D The lock nut is in the center of the tension pulley hard up against the inner wing. Either take a digital photo or sketch it so that you can route the belt properly when re-fitting. When you look at the belt installed it will look obvious where it runs but when you take it off, trust me it will by like a crypton factor puzzle. You may be able to peg the tensioner in the belt relaxed position.Ī word of advice. Generally the tensioners have a hex or square drive in the pulley mounting braket and you need only to apply a turning moment to oppose the tensioning spring. This will take you exactly to your model in the manual. It will probably be configered like this as an example "ACA30". You need the model code from the passenger side b pillar. I have looked through my files and don't actually have the specific information you are looking for but the entire workshop manual is on line from Toyota here The life of the belt is extended by having low tension, multiple V's to increase area and a large proportion of the belt in contact with the pulley. The tensioner for most serpentine belts is only spring loaded. Please amend your profile to show more details on your model.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |